Getting To Know Your Appliance; Controls And Burners - Bosch PRA3A SERIES Instruction Manual

Operating a burner with the power set too
■
high will result in very high temperatures
being generated. This may cause
flammable materials to ignite. The power
setting shown in the display may differ from
the power setting that has been set using
the knob. The power setting is shown in the
display purely for additional information.
Always set the power setting according to
the printing on the knob.
:
Warning – Risk of injury!
Cracks or fractures in the glass plate are
■
dangerous. Shut immediately off all burners
and any electrical heating element. Unplug
the appliance from the mains or switch off
the circuit breaker in the fuse box. Shut off
the gas supply. Do not touch the appliance
surface. Never switch on a faulty appliance.
Contact the after-sales service.
Pans which are damaged, are not the right
Risk of injuries!
■
size, hang over the edge of the hob or are
not positioned correctly can cause serious
injuries. Follow the advice and warnings
provided relating to the cooking pans.
In the event of a malfunction, turn off the
Risk of injuries!
■
appliance's gas and electricity supply. For
repairs, call our Technical Assistance
Service.
Do not tamper with the appliance's interior.
Risk of injuries!
■
If necessary, call our Technical Assistance
Service.
If a control knob is too stiff to turn or it is
Risk of injury!
■
loose, it must not be used. Contact our
after-sales service immediately to have the
control knob repaired or replaced.
:
Warning – Risk of electric shock!
Do not clean the appliance using steam
■
cleaners.
Cracks or fractures in the glass plate could
Risk of electric shock!
■
cause electric shocks. Switch off the circuit
breaker in the fuse box. Contact the after-
sales service.

Getting to know your appliance

*Getting to know your
appliance
You can find your appliance and the burner powers in
y o u r a p p l i a n c e G e t t i n g t o k n o w
the model overview. ~ Page 2

Controls and burners

Each control knob is marked with the burner it controls.
You can use the control knobs to set the output
required in each case to various positions between the
maximum and the minimum settings. Never try to switch
directly from position 0 to position 1 or from position 1
to position 0.
Indicators
Burner controlled by control knob
Ì
Switched-off burner
Û
— 9 Highest power setting and electric ignition
1 ˜ Lowest power setting
Displays
Electric ignition
³
Heat settings
Š-‚
Switched-off burner
‹
Residual heat
•-œ
For dual double-flame burners, the inner and outer
flames can be controlled separately. The available
power levels are as follows:
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.
en
5