Table of Contents
Advertisement
Fat or oil which is overheated can catch fire
■
easily. Never leave fat or oil to heat up
unattended. If oil or fats do catch fire, never
use water to put the fire out. Put the fire out
by covering the pan with a lid and switch off
the hotplate.
:
Warning – Risk of injury!
Cracks or fractures in the glass plate are
■
dangerous. Shut immediately off all burners
and any electrical heating element. Unplug
the appliance from the mains or switch off
the circuit breaker in the fuse box. Shut off
the gas supply. Do not touch the appliance
surface. Never switch on a faulty appliance.
Contact the after-sales service.
Risk of injuries!
Pans which are damaged, are not the right
■
size, hang over the edge of the hob or are
not positioned correctly can cause serious
injuries. Follow the advice and warnings
provided relating to the cooking pans.
Risk of injuries!
The pan may suddenly jump due to the
■
presence of liquid between the base of the
pan and the hotplate. Always ensure that
the hotplate and the bottom of the pan are
kept dry.
Risk of injury!
Incorrect repairs are dangerous. Repairs
■
may only be carried out, and damaged
power and gas lines replaced, by an after-
sales engineer trained by us. If the
appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales
service.
Risk of injury!
If a control knob is too stiff to turn or it is
■
loose, it must not be used. Contact our
after-sales service immediately to have the
control knob repaired or replaced.
:
Warning – Risk of electric shock!
Do not clean the appliance using steam
■
cleaners.
Risk of electric shock!
Cracks or fractures in the glass plate could
■
cause electric shocks. Switch off the circuit
breaker in the fuse box. Contact the after-
sales service.
Getting to know your appliance
*Getting to know your
appliance
Y ou can find your appliance and the burner powers in
G e t t i n g t o k n o w y o u r a p p l i a n c e
the model overview. ~ Page 2
Controls and burners
Each control knob is marked with the burner or hotplate
that it controls. You can use the control knobs to set the
output required in each case to various positions
between the maximum and the minimum settings.
Indicators
Hotplate controlled by control knob
‰
Hotplate off
Û
9
Highest power setting
1
Lowest power setting
Larger hotplate
ð
Residual heat indicator
e
— 9
Highest power setting and electric burner ignition
1 ˜
Lowest power setting
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Burner parts
1
Ignition plug
2
Thermocouple
3
Burner ring
4
Burner cup
5
Burner cap
en
5
Advertisement
Table of Contents
