Table of Contents
Advertisement
*Getting to know your
appliance
The instruction manual is the same for various different
y o u r a p p l i a n c e
G e t t i n g t o k n o w
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2
The control panel
Displays
Heat settings
‚-Š
Residual heat
•/œ
Electronic boil start control
'
Timer
‰‰
Touch controls
Main switch
#
Wipe protection
>
Child safety lock
D
Hotplate selection
$
1û2û3û4û
Settings area
Electronic boil start control
w
Timer
0
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors.
■
The electronics could overheat.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If • appears in the display the hob is still hot. It may be
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to œ. The display remains lit
until the hotplate has cooled sufficiently.
Getting to know your appliance
1Operating the appliance
In this section, you can find out how to set the hotplates.
p l i a n c e
O p e r a t i n g t h e a p
The table shows heat settings and cooking times for
various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the # symbol. A signal sounds. The
display light above the main switch and the ‹ indicators
light up. The hob is ready for use.
To switch off: Touch the # symbol until the display light
above the main switch and the displays go out. All
hotplates are switched off. The residual heat indicator
remains on until the hotplates have cooled down
sufficiently.
Notes
The hob switches off automatically if all hotplates
■
have been switched off for more than 20 seconds.
The settings remain stored for 4 seconds after the
■
hob has been switched off. If you switch it on again
during this time, the hob will operate using the
previously stored settings.
Setting a hotplate
Set the desired heat setting on the control panel.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Every heat setting has an intermediate setting. This is
marked in the control panel with the û symbol.
en
5
Advertisement
Table of Contents
