UAZ -374195 Operation Manual page 98

Adjust the cable length (when replacing the cable) as follows:
1. Move brake lever 1 into its extreme front position.
2. Unscrew the locknuts of adjusting yoke 7, remove the snap pin
and take out the stud, which connects the yoke with brake drive lever.
3. Adjust the cable length by turning the adjusting yoke, until the
orifices in the yoke and the lever coincide, and choose the cable slack.
The lever must contact the housing of the release mechanism balls.
4. Unscrew the adjusting yoke for 1.5–2 torques, combine the orifices
in the yoke and the lever, install the stud, secure with a cotter and tighten
the locknuts.
If adjusted correctly, the vehicle shall brake when the lever pawl is
installed into the 2nd or 3rd sector slot from the rear part (2–3 clicks).
It is forbidden to check the parking brake system while moving.
It shall be done only on a slope.
98