UAZ -374195 Operation Manual page 62

1 — crankshaft damping pulley; 2 — tensioning roll; 3 — tensioning roll fixing bolt; 4 —
adjusting bolt; 5 — water pump and alternator driving belt; 6 — alternator; 7 — inlet pipe;
8 — receiver; 9 — throttle unit with throttle position sensor; 10 — fan pulley; 11 — oil
filling neck cap; 12 — power steering pump pulley; 13 — power steering pump fixing bolt;
14 — adjusting bolt; 15 — water pump pulley; 16 — fan and power steering pump drive belt
Exhaust gas leaks from the exhaust system connections fitted with
gaskets are not allowed and shall be eliminated on the first occasion.
Stuck nuts shall be tightened (see Appendix 2) with preliminary wetting
of thread connections with special liquids or kerosene.
When the feed system or the ignition system is faulty, a lot of unburnt
hydrocarbons ingress into the converter and due to this, the temperature
in the converter can rise above the admissible limit and the converter will
fail. So, special attention shall be paid to operation of the feed system
and the ignition system. Three-cylinder-based operation of the engine
is prohibited even for a short period of time.
Fig. 9.5. Aggregates drive belt tension
62