UAZ -374195 Operation Manual page 36

VII (push) — high beam is On, if headlights are switched on by the
external lights switch (stable position).
2 — wiper and washer lever with the following positions:
I — wiper and washer are OFF;
II — windshield intermittent wiper is On (unstable position);
III — windshield intermittent wiper is On (stable position);
IV — windshield wiper constant mode (low speed) is On (stable
position);
V — windshield wiper constant mode (high speed) is On (stable
position);
VI (pull) — windshield wiper and washer are On (unstable position);
VII, VIII — not used.
3 — horn buttons.
4 — ignition switch with four positions:
0 — everything is off (stable position);
I — ignition is On (stable position);
II — starter motor is On (unstable position);
III — parking (stable position).
The key can be removed from the lock only in position III; in this
position, the locking device mechanism actuates and locks the steering
system shaft.
To lock the steering system in park, set the key to position III, remove
it and turn the steering wheel in any direction until it clicks, indicating
that the locking device catch has matched the groove of the steering
wheel shaft stop sleeve.
To unlock the steering system insert the key into the ignition starter
switch and, swaying the steering wheel right and left, turn the key
clockwise to position 0.
In order to avoid erroneous starter switching on with the engine on
(II key position), the switch mechanism includes locking that enables
engine re-start only after the key is returned to position 0.
Attention! It is not allowed to cut off IGn and remove the key from
the ignition starter switch while driving a motor vehicle. Engine stoppage
will lead to braking capacity reduction, and the steering system shaft is
blocked by the anti-hijack device when removing the key, and a motor
vehicle gets becomes uncontrollable.
36