UAZ -374195 Operation Manual page 83

When replacing the bearings, tighten the nut with the torque of 35–40
N · m (3.5–4.0 kgf · m) and the locknut with the torque of 25–30 N · m
(2.5–3.0 kgf · m).
Install the lock washer with its inner tab into the stub axle slot. If the
lock washer tabs have any cracks, replace the washer.
8. Check the bearings adjustment after tightening the locknut. If
the adjustment is correct, the wheel shall rotate freely without binding,
noticeable axial clearance or wobbling.
9. Bend one tab of the lock washer round the nut flat and the other
tab round the locknut flat until its full fitting to the flats. Unbend the tabs,
which are the closest to centers of the nut flats.
10. Install the rare axle shaft or the flange of the front axle hub, clean
the threaded part of the bolts from old sealant, degrease them and apply
fresh UG-6 sealant, tighten the bolts.
When checking the bearings adjustment for heating do not use the
pedal brakes, as the hubs can be heated from the brake discs or drums.
83