UAZ -374195 Operation Manual page 102

Fig. 9.37. Battery of UAZ-220695, UAZ-396295:
1 — hood; 2 — ventilation tube; 3 — plus terminal; 4 — adapter; 5 — battery; 6 — minus
terminal
- check the relay switch outputs and the working surface of electric
terminals;
- check the starter motor drive — a gear, a lever and a spring;
- clean rubbing parts from dirt and lubricate them with litol-24 grease
as required.
The starter motor drive shall move freely with no jamming at the
shaft splines, and it shall be brought back to the initial position by the
return spring. The anchor shall not revolve when the drive gear goes to
the working rotation direction. In case of reverse rotation the gear shall
revolve with the shaft. Turn the shaft by hands to check the ease of rotor
rotation in bearings with the brushes lifted.
Warnings:
1. The sleeve of the starter motor travel can be broken if the starter
motor is on after the engine begins working.
2. Do not wash the starter motor caps and the drive with gasoline or
kerosene to avoid grease removal from bronze graphite cellular plain
bearings.
ATTENTION! It is forbidden to move the vehicle with the
starter motor. The starter motor shall work not more than 10 seconds
uninterruptedly. Turn on the starter motor again after at least 1 minute,
but for no more than 3 times totally. If the engine cannot be started,
detect and eliminate the malfunction.
102