Hilti TE 50 Operating Instructions Manual page 11

WARNING
Risk of injury! The accessory tool becomes hot in use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
Note
Use only genuine Hilti grease. Use of unsuitable grease may cause damage to the product.
5.5 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
Note
The chisel can be set to 24 different positions (in 15° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum working position.
1. Set the function selector switch to the
2. Rotate the chisel to the desired position.
3. Set the function selector switch to the
◁ The tool is ready for use.
Printed: 08.03.2017 | Doc-Nr: PUB / 5130201 / 000 / 03
position.
position and make sure the switch engages.
English 9