Fuel Pump - Aerotech BT 400-46 Installation And Operation Maintenance

Section 5
• • • • • • • • • • • • • • • •
5.49 Ignition Cable and Igniter Plug Installation
5.50 To install ignition cable and igniter plug, proceed as follows:
(a) Install the igniter plug in the combustion plate. Measure the point gap. The gap should be
0.125 inch to 0.1875 inch (1/8 to 3/16). Bend the electrode to obtain
correct gap (see figure 5-3).
(b) Install combustion plate on combustion chamber.
(c) Insert nozzle holder, with clamp in notches on combustion chamber.
(d) Insert ignition cable to igniter plug and magneto.
(e) To install fan and mounting ring, follow procedures listed in paragraph 5.33.
5.51

Fuel Pump

5.52 The fuel pump is mounted on a bracket installed opposite the coil. The pump is belt driven by the engine.
!CAUTION!
Do not bend the igniter plug electrode
Figure 5-3 • Igniter Plug Adjustment Points
• • • • • • • • • • • • • • • •
AEROTECH HERMAN NELSON INTERNATIONAL INC.
100 Eagle Drive, Winnipeg, Manitoba Canada R2R 1V5
Phone: 204-633-1999 (24 Hours) Fax: 204-694-1612 Email:
Check Out Our Web site
31
www.hermannelson.com New Items Added Weekly
12.18.07 REVISION 1.02
Air4ce45@aol.com