Aerotech BT 400-46 Installation And Operation Maintenance page 30

Table 5-2
• • • • • • • • • • • • • • • •
COMPONENT
OR PART
Heater unit
Fuel tank
Air ducts
Engine crankcase
Engine air filter
Batteries
Pneumatic tires
Air TEMP gauge
Exhaust system
Burner control valve
Temperature selector
valve
Fuel filter
Engine
Fuel pump
V-belt
Coupling
Fuel lines
Ignition system
Electrical wiring and
cables
Burner nozzle
Heat exchanger
Heater unit
Ventilating air
• Inspection, Checks & Services
INSPECTION, CHECK OR SERVICE
Visually inspect for loose or missing hardware.
Inspect vent hole, fuel cap and fuel level gauge
Inspect for damage or wear. Replace as necessary.
Check oil level, add oil if necessary.
Check for dirt. Clean if necessary.
Check electrolyte level, fill to proper level with distilled water.
Check tire pressure; add air if necessary. Check for tire wear.
Inspect for visible damage.
Inspect for secure mounting, cracks or dents. Inspect exhaust
stack and extensions for damage. Check screen for damage.
Clean or replace as necessary.
Check valve for leakage and operation. Replace a defective
valve.
Inspect for visible damage. Check operation. Replace a
defective valve.
Replace filter, refer to FUEL FILTER (paragraph 5.18).
Check cooling air inlet openings for dirt. Clean if necessary.
Check for damage, corrosion and loose hardware. Retighten
hardware as necessary.
Clean fuel pump strainer, refer to CLEANING FUEL PUMP
STRAINER (paragraph 5.69). Check pump for proper
operation and leakage. Replace a defective pump.
Inspect for wear, fraying or stretching, and for proper
deflection. Adjust tension, refer to v-belt if necessary.
Inspect for damage. Replace if necessary.
Inspect entire fuel system for leaking connections. Tighten as
necessary.
Check system, refer to IGNITION SYSTEM (paragraph 5.42).
Visually inspect for loose connections, damage, and corrosion.
Tighten, replace or clean as necessary.
Inspect for carbon deposits or other defects. Clean or replace
as necessary.
Inspect for carbon deposits or other defects. Clean or replace
as necessary. Refer to HEAT EXCHANGER (paragraph 5.36)
Inspect for loose or missing hardware and corrosion. Clean
entire unit (paragraph 5.4)
Perform CARBON MONOXIDE TEST (paragraph 5.40).
AEROTECH HERMAN NELSON INTERNATIONAL INC.
100 Eagle Drive, Winnipeg, Manitoba Canada R2R 1V5
Phone: 204-633-1999 (24 Hours) Fax: 204-694-1612 Email:
Check Out Our Web site
24
www.hermannelson.com New Items Added Weekly
12.18.07 REVISION 1.02
OPERATIONAL
TIME PERIOD
8 hours or daily
8 hours or daily
8 hours or daily
8 hours or daily
8 hours or daily
25 hours or weekly
25 hours or weekly
25 hours or weekly
25 hours or weekly
150 hours or monthly
150 hours or monthly
300 hours or 3 months
300 hours or 3 months
300 hours or 3 months
300 hours or 3 months
300 hours or 3 months
600 hours or 6 months
600 hours or 6 months
600 hours or 6 months
600 hours or 6 months
600 hours or 6 months
600 hours or 6 months
600 hours or 6 months
Air4ce45@aol.com