Specifications - Makita JS1600 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock-off lever in the FREE position
1-2. Switch lever (Paddle switch)
2-1. Lock-off lever in the LOCK position
3-1. Lock-off lever
3-2. Switch lever
4-1. Gauge for stainless: 1.2 mm (3/64")
4-2. Gauge for mild steel: 1.6 mm (1/16")
5-1. Lower blade
5-2. Loosen
5-3. Upper blade
5-4. Upper blade securing bolt
5-5. Hex wrench

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting sheet metal
Vibration emission (a
Explanation of general view
6-1. Thin washers
6-2. Blade holder
6-3. Upper blade
6-4. Upper blade securing bolt
7-1. Tighten
7-2. Upper blade securing bolt
7-3. Upper blade
8-1. Blade holder
8-2. Upper blade securing bolt
8-3. Upper blade
8-4. No gap allowed
9-1. Lower blade
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Safety class
) : 78 dB(A)
pA
2
) : 6.5 m/s
h
2
2
2
2
ENE037-1
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG104-2
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG218-2
3
9-2. Tighten
9-3. Yoke
10-1. Yoke
10-2. Lower blade positioning screw
10-3. Lower blade
11-1. Workholder
13-1. Cutting line
14-1. Limit mark
15-1. Screwdriver
15-2. Brush holder cap
JS1600
1.6 mm (16 ga.)
1.2 mm (18 ga.)
0.8 mm (22 ga.)
2.5 mm (13 ga.)
30 mm
4,000
230 mm
1.8 kg
/II
2
ENG901-1