Advertisement
3. Connect the supply wires to the fan wires at the
top of the downrod by using the wire connectors
(supplied). Do not connect the red and black
wires labelled 'light' unless a light is being fitted
to the fan. The Ceiling Fan and downrod must be
earthed.
4. Install the upper canopy to the cover
connections by tightening two securing screws
on the underneath of the bracket. Ensure the
paint-cutting washers provide solid earthing of
the canopy.
5. Secure the blades to the motor assembly.
6. Tighten all screws, ensuring the earth locking
screws are secured.
7. Connect the speed controller as per wiring
diagram.
�����
�
�����
�
����
��
�����
����
�����
Fan Blade Attachment
����
������
������
������
���������
������
������
�������
���������
�
�
�
����� ����
���������
������
������
�������
���
�����
Three Speed Flush Control
Note: Only use the speed control switch
supplied with this fan. Electronic speed
controllers will not work with this Ceiling Fan.
1. The speed control will fit into any existing single
gang block or wall plate. If you are not flush
mounting the control, use a standard single
gang mounting block.
2. Connect the wires as indicated on the control.
A for active, F for fan load.
��� ����
������
�����
Note: Reverse connection of the speed control
will effect the operation of the Ceiling Fan.
3. Select the desired position of the reverse switch.
Warm weather – Have the airflow directed
Cool weather –
4. Set the wall control to desired speed.
5
����� �������
�
�
downwards.
Have the airflow directed
upwards.
������
Advertisement
