GENERAL SAFETY PRECAUTIONS 1. This appliance is intended for indoor and household use only; not for outdoor, commercial and industrial use. No responsibility is accepted for damage resulting from improper use or noncompliance with the instructions. 2. Please keep this instruction manual for future reference. If the appliance is passed to another person, this manual should accompany it.
PARTS IDENTIFICATION 1. Base 2. Front Housing 3. Blade Rod 4. Cross Blade 5. Air Line A 6. Control Panel 7. Display Panel 8. Remote Control Compartment 9. Back Cover 10. Rear Housing Control Panel Display Panel...
Page 4
Accessories Remote Control SPECIFICATIONS Model MFD-500R Rated Voltage 220-240V~ Rated Power Frequency 50Hz FUNCTIONS & FEATURES 1. 3 wind modes: Natural/ Normal/ Sleeping; 2. 3 wind speeds: Hi/ Mid/ Low; 3. Horizontal Oscillation within 80 ° angle; 4. 1, 2, 4, 8 hours timing;...
Page 5
Assembly of Tower Fan 1. Open the package and get out the unit: Check whether the parts are complete, Including Warranty Card, Instruction Manual, Remote Controller, Disc Screw. 2. Finish assembling as shown below. Step 1 Step 2 1) Put the fan on soft place (to avoid any scratches to the fan surface) 2) Install the front base and back base to a whole unit.
Page 6
ON/ SPEED a. Press the ON/SPEED button to turn on the appliance, the system originally set on “Mid” speed, shift to “Low” automatically after 3 seconds; b. The system retains the working conditions set before turn OFF under the condition of unplugging the socket after start-up (Not the first boot).
Page 7
d. Sleep: Fan motor under computer program control in Sleep Mode. Air volume will reduce with the decrease of room temperature, which protect human from catching cold. It reduce as below rule. - The unit works for half an hour in Hi natural wind, then shift to Mid natural wind, then to Low half an hour later, till the end of preset time or turned off under the setting of Hi sleeping wind mode;...
Page 8
Remote Controller Instructions 1. Open the cover at the back of the controller. Install a battery of 3V CR2032. 2. Align with the receiver when work. 3. Replace battery when it’s power off, pull out the cover as shown. Please mind the Plus-n- Minus of the battery.
Page 9
Distributed by: KHIND ALLIANCES SDN BHD (811092-W) No.2, Jalan Astaka U8/82, Seksyen U8, Bukit Jelutong, 40150 Shah Alam, Selangor D.E., Malaysia. Tel: 603- 7839 2000 Fax: 603-7845 0300 Customer Care line: 1300 8000 32 Website: www.khindalliances.com | www.mistral.com.my Email: kas.inquiry@khind.com...
Need help?
Do you have a question about the MFD-500R and is the answer not in the manual?
Questions and answers