Allen-Bradley 2080-LC20-20QWB User Manual page 147

Rockwell Automation Publication 2080-UM005B-EN-E - March 2015
6. Click Transfer.
The file is copied to the microSD card.
7. Close the SD Card Utility and proceed to the next step to edit the
ConfigMeFirst.txt file.
Step 2 – Edit the ConfigMeFirst.txt File
To flash upgrade the controller with the firmware that you have transferred to the
microSD card, you need to edit the ConfigMeFirst.txt file with the settings listed
below. These settings must be added at the beginning of the file.
New ConfigMeFirst.txt Configuration Settings for Flash Upgrade
Setting Description
[FLASHFILE] File path location of the firmware revision on the microSD card. The
default location is in the following format:
firmware\<catalog number>\<filename of firmware>
[FWBUS] This setting is reserved and may be omitted.
[FWSLOT] This setting is reserved and may be omitted.
[FWDOWN] Sets whether to upgrade or downgrade the controller firmware from the
current revision.
0 = Upgrade firmware; 1 = Downgrade firmware
Example of ConfigMeFirst.txt File for Flash Upgrade
After you have edited the file, insert the microSD card into the controller. Power
cycle the controller and the flash upgrade process will begin. Note that the SD
status LED will not blink when flash upgrading the firmware from the microSD
card is in progress.
Quickstarts Appendix C
139