Fitting The Handles - Westinghouse WHE6200S User Manual

INSTALLATION OF WHE6200 (CONTINUED)
4. Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level. You can
adjust the level with the stability feet as detailed in
step 3.
Aligned to
cupboards
ie. even gap
5. If you find your refrigerator rocks from corner to
corner, it means your floor is uneven. Find a piece of
plastic or hardboard etc. and pack it firmly under the
foot.
6. On certain floor surfaces the refrigerator may roll
forward during operation. A "Roller Stop", can be
placed under the front roller. If Roller Stop is required,
contact our customer care team.
7. You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5.
A (top)
B (right)
Top of refrigerator is
level ie. horizontal
Adjust front
stability feet for
uneveness of floor
eg. wind this foot
down or up
Roller stop

Fitting the handles

1. Remove the handles from the packaging
2. Fit the refrigerator handle by aligning the handle with
its upper and lower mounting locations on the door
with the handle top end facing upward (as shown in
the below illustration).
3. Pull the handle down until you hear a "click"
4. Repeat this with the other refrigerator handle.
5. Next, fit the freezer handle (B).
Left
B (freezer handle)
6. Align the freezer handle with the mounting location
on the freezer door (as shown in the above
illustration).
7. Pull the handle to the right until you hear a "click"
8. Clean your refrigerator thoroughly following the
instructions on page 12 and wipe off any dust that
has accumulated during shipping.
9. Plug your refrigerator straight into its own power
point and never use a double adapter.
10.. Before you put any food in your refrigerator, it is
recommended you leave it on for 2 or 3 hours to
check it is running properly and the appropriate
temperature is reached.
Top
A (refrigerator handles)
FITTING THE HANDLES
7