Fujitsu D2532 Technical Manual page 31

SAS/IME configuration program
Menu Spinup Properties
It is recommended: don't change this setting.
 LSI Logic MPT Setup Utility
 Spinup Properties -- SAS1068
 ______________________________________________________________________________


Direct Attached Spinup Delay (Secs)


Direct Attached Max Targets to Spinup


Expander Spinup Delay (Secs)


Expander Max Target devices to Spinup









 ______________________________________________________________________________
 Esc = Exit Menu

Spinup Delay Defines the intervals for the spinup of the hard disks.
The default setting is 2.
When this feature is enabled, the SAS devices which support
this function are not started by switching on the server until
they receive a „Start Unit" command from BIOS of the SAS
controller.
This function is used to distribute the high starting currents of
the SAS devices over a specific period and to release the power
supply of your server.
D2532 (RX100 S4)
F1/Shift+1 = Help
[ 2]
[ 0]
[ 0]
[ 0]























31