Installation; Basic Installation; Removing The Existing Receiver Unit; Iso-Din Installation - LG LAC6900N Owner's Manual

Installation

Basic Installation

Bend the claws
according to
the thickness
of the
dashboard
Control panel

Removing the existing receiver unit

A
A
8 CAR CD/MP3/WMA Receiver
Downloaded from Caradio-Manual.com Manuals
Before installing, make sure that the
ignition-switch is set to OFF and
remove the terminal of the car battery
to avoid short-circuiting.
1 Remove the existing receiver unit.
2 Make the necessary connections.
3 Install the installation sleeve.
4 Install the unit into the installation
sleeve.
If there is already an installation
sleeve for the receiver unit in the
dashboard, it must be removed.
1 Remove the rear support from the
unit.
2 Remove the control panel and trim
ring from the unit.
3 Insert the lever A into the hole on
one side of the unit.
Perform the same operation on
the other side and pull the unit out
from the mounting sleeve.

ISO-DIN Installation

1
2
1
3
4
3
5
4
2
6
5
6
Control panel

Battery Installation

1
2
3
Note
• Use only one CR2025 (3V) lithium battery.
• Remove the battery if the remote control is not used for a long period of
time.
• Do not leave the product in a hot or humid place.
• Do not handle the battery with metallic tools.
• Do not store the battery with metallic materials.
Slide the unit into the ISO-DIN
frame.
Fit screws removed from the old
unit.
Slide the unit and frame into the
dash opening.
Install the dash panel or adapter
plate.
Install the trim ring to the unit.
Install the control panel to the unit.
Pull out the battery holder with a
sharp product like a ball point pen.
Put the battery with and
correctly on the battery holder.
Push the battery holder back into
its original position.