Connect To A Power Source - Polaris 9650iQ Sport Owner's Manual

Connect to a Power Source

• Failure to comply with the following warnings can result in permanent injury,
electrocution or drowning.
• Prevent Electrical Shock
• U.S.: Per NEC
requirements, keep the control unit at least five (5) ft. (1.5 m) from
®
the edge of the pool. CANADA: Per CEC requirements, keep the control unit at
least three (3) m (10 ft.) from the edge of the pool.
• Only connect the control unit to a receptacle protected by a ground fault circuit
interrupter (GFCI). Contact a certified electrician if you cannot verify that the
receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control unit is water-resistant, not waterproof. In order to prevent electrocution,
never submerge the control unit or leave exposed to inclement weather.
1. Unscrew the protective cap for the floating cable from the side of the
control unit by turning counter-clockwise (Figure 10).
Figure 10. Remove Protective Cap
WARNING
Page 11