Headstock - Grizzly G0762 Owner's Manual

Headstock

Lube Type .. Model SB1365 or ISO 68 Equivalent
Lube Amount .............................................3
Check/Add Frequency ........... 8 hrs. of Operation
Change Frequency ................................ Annually
The headstock has the proper amount of oil when
the sight glass shown in Figure 38 is halfway full.
Sight
Glass
Figure 38. Headstock oil fill plug and sight glass.
Tool Needed
Hex Wrench 8mm .............................................. 1
To change headstock oil:
1.
Run spindle at 670 RPM for approximately 10
minutes to warm oil.
2.
DISCONNECT MACHINE FROM POWER!
3. Remove fill plug (see Figure 38).
-32-
⁄ qt.
1
4
Fill
Plug
Qty
4. Place a 1-gallon or larger drain pan on table
under headstock.
5. Remove drain plug (see Figure 39) from
underneath headstock and allow oil to drain
into pan.
Figure 39. Headstock drain plug
(headstock tilted 90° for clarity).
Follow federal, state, and local require-
ments for proper disposal of used oil.
6.
Replace drain plug.
7.
Add oil until sight glass is halfway full, then
replace fill plug.
8.
Clean up any spilled oil to prevent slipping
hazards.
Model G0762 (Mfd. Since 5/14)
Drain
Plug