Fiat 124 SPIDER ABARTH 2017 User Manual page 158

Take care not to allow the contents of
Tire Service Kit to come in contact with
hair, eyes, or clothing. Tire Service Kit
sealant is harmful if inhaled, swallowed, or
absorbed through the skin. It causes skin,
eye, and respiratory irritation. Flush
immediately with plenty of water if there is
any contact with eyes or skin. Change
clothing as soon as possible, if there is
any contact with clothing.
Tire Service Kit Sealant solution contains
latex. In case of an allergic reaction or rash,
consult a physician immediately. Keep
Tire Service Kit out of reach of children.
If swallowed, rinse mouth immediately with
plenty of water and drink plenty of water.
Do not induce vomiting! Consult a
physician immediately.
U.S.A. And CANADA Markets:
Proceed as follows:
1. Pull over to a safe location and turn
on the vehicle's Hazard Warning Lights.
2. Verify that the valve stem (on the
wheel with the deflated tire) is in a
position that is near to the ground. This
will allow the Tire Service Kit hoses to
reach the valve stem and keep the Tire
Service Kit flat on the ground. This will
provide the best positioning of the kit
when injecting the sealant into the
deflated tire and running the air pump.
156
Move the vehicle as necessary to place
the valve stem in this position before
proceeding.
3. Place the gear selector in REVERSE
for a manual transmission, and PARK
for automatic transmission.
4. Apply the parking brake with the
brake pedal pressed and cycle the
engine OFF.
5. Unload passengers and cargo, then
remove the Tire Service Kit.
Tire Service Kit Location
6. Gently shake the sealant bottle to
mix the contents. Then extend the
injection hose.
Sealant Bottle With Injection Hose
1 — Injection Hose
Note:
Do not shake the bottle
excessively. Otherwise, the sealant
could spray out of the injection hose.
If the sealant contacts clothing or other
objects, you may not be able to
remove it.
The sealant hardens easily, and
08020202-121-003
injecting it will be difficult under cold
weather conditions (32 °F (0 °C) or
below). Warm the sealant inside the
vehicle to facilitate injection.
08020202-03A-666