Fiat 124 SPIDER ABARTH 2017 User Manual page 122

Deactivating Speed Control
Push the OFF/CAN button. The
warning light (amber) in the
instrument cluster turns off.
When a speed has been set: the
warning light (green) in the
instrument cluster is illuminated, push
and hold the OFF/CAN button or push
the OFF/CAN button twice to
deactivate.
When a speed has not been set: the
warning light (amber) in the
instrument cluster is illuminated, push
the OFF/CAN button to deactivate.
Setting A Desired Speed
Proceed as follows:
1. Activate the Speed Control device
by pushing the ON button. The cruise
warning light (amber) illuminates.
2. Accelerate to the desired speed,
which must be more than 25 mph
(40 km/h).
3. Set the Speed Control by pushing
the SET (-) button at the desired speed.
The Speed Control is set at the
moment the SET (-) button is pushed.
Release the accelerator pedal
simultaneously. The
(green) illuminates.
120
Note:
The Speed Control setting cannot be
performed under the following
conditions:
Automatic transmission: the gear
selector is in the PARK or NEUTRAL
position.
Manual transmission: the gear
selector is in the NEUTRAL position or
when the clutch is disengaged (clutch
is depressed).
The parking brake is applied.
Release the SET (-) button at the desired
speed, otherwise the speed will continue
decreasing while the SET (-) button is
pushed and held (except when the
accelerator pedal is depressed).
Note:
Release the SET (-) button at the
desired speed, otherwise the speed
will continue decreasing while the SET
(-) button is pushed and held (except
when the accelerator pedal is
depressed).
On a steep grade, the vehicle may
momentarily slow down while
ascending, or speed up while
warning light
descending.
The Speed Control will cancel if the
vehicle speed decreases below
16 mph (25 km/h) when climbing a
steep incline.
The Speed Control may cancel at
about 9 mph (15 km/h) below the
preset speed such as when climbing a
long, steep incline.
The vehicle's set speed is displayed in
the instrument cluster.
Increasing / Decreasing
Speed
To Increase Speed
With the Speed Control button: push
the RES (+) button and hold it your
vehicle will accelerate. Release the
button at the desired speed. Push the
RES (+) button and release it
immediately to adjust the set speed.
Multiple operations will increase the set
speed according to the number of
times it is operated.
Using accelerator pedal: press the
accelerator pedal to accelerate to the
desired speed. Push the SET (-) button
and release it immediately.