Dll6000-R Compatibility; Dragon™ M/Om-Dragon™ Stand Alone Setup - Datalogic DRAGON M SERIES Quick Reference

UK/US

DLL6000-R COMPATIBILITY

If it is necessary to use the DRAGON™ M reader in DLL6000-R applications,
full radio protocol and software compatibility is provided by reading the following
code:
The reader will automatically be switched off and restarted and four high tones
will be emitted.
At this point, the DRAGON™ M reader is ready to be configured using the
DLL6000-R procedure; refer to the DLL6000-R Quick Reference or System
Manual. For your convenience, the DLL6000-R configuration procedure is also
included at the end of this manual.
Do not use the DRAGON™ M configuration procedure.
To restore the DRAGON™ M standard configuration read the following code,
then follow the DRAGON™ M configuration procedure below:
Restore DRAGON™ M standard configuration
DRAGON™ M/OM-DRAGON™ STAND ALONE
SETUP
When the OM-DRAGON™ is connected and powered, configure the
DRAGON™ M by reading the following codes in the given sequence and follow
the instructions.
Note: for the numeric code selection use the table at the end of this Quick
Reference.
1.
2.
6
Set DLL6000-R compatibility
Restore DRAGON™ M default
Enter configuration
DATALOGIC