Native Instruments MASCHINE Manual page 622

Hide thumbs Also See for MASCHINE:

Table of Contents

SLICER Section

Grid mode only)

APPLY Section

Here you can select either Split, Grid, Detect or Manual:

Detect mode: The Sample will be sliced according to its transients.

Split mode: The Sample will be sliced into equally spread Slices.

Grid mode: The Sample will be sliced according to note values.

Manual mode: Manually enter slice points using the pads on your

controller, or adjust the start and end points of a slice.

amount of Slices: 4, 8, 16 or 32.

length of the Slices in note values: 4th, 8th,16th or 32nd notes.

The Sample Slicer Manual mode Auto-Snap feature automatically

aligns Slice points to the nearest transient as you manually trigger

the slicing from the pads. It can be turned off so that slice points are

instead placed exactly where you trigger them. In order to use Auto-

Snap, you must wait for analysis to be performed on the sample

you're slicing—the analysis is very quick but will take longer for long

audio files.

adjust the sensitivity of the transient detection. Higher values will

cause more Slices to be detected because more transients will be

recognized, lower values will result in less Slices. This parameter

should be adjusted until all the musically significant slices are being

detected in the waveform.

(see above),

lets you choose the

(see above),

lets you choose the

(see above),

Sampling and Sample Mapping

Slicing a Sample

MASCHINE 2 - Manual - 622