Mitsubishi QJ71MB91 User Manual page 289

10
DEDICATED INSTRUCTIONS
(2) Control data
Device Item
(S1)+0 - Specify 0.
The status of the instruction completion is stored.
Completion
0
(S1)+1
status
Other than 0: Error completion (error code) (
(S1)+2 - Specify 0.
Specify the target channel.
(S1)+3 Channel 1: RS-232
2: RS-422/485
(S1)+4 - Specify 0.
Specify the station number of the target slave.
Target station
(S1)+5
0
No.
1 to 247: Slave station No.
(S1)+6 - Specify 0.
[Response monitoring timer value (Target station No. is 1 to 247)]
Specify the time for monitoring a response from the target device (slave).
(Unit: 10ms)
0
2 to 65535: Set value (Response monitoring timer value = set value x 10ms)
Response
monitoring
[Broadcast delay value (Target station No. is 0)]
(S1)+7 timer value/
Specify the wait time after broadcast transmission. (Unit: 10ms)
Broadcast
0
delay value
2 to 65535: Set value (Broadcast delay value = set value x 10ms)
For details on the Response monitoring timer value/Broadcast delay value,
refer to the following.
Table10.10 Control data of the MBREQ instruction
Setting data
: Normal completion
*2
: Broadcast
: 30 seconds
: 400ms
Section 7.2.1 (4)
* 1 The setting side is as described below.
User : Data are set by the user before dedicated instruction execution.
System: The programmable controller CPU stores the result of dedicated instruction execution.
* 2 For function codes that can be broadcast, refer to the following:
Section 4.1
* 3 When specifying a value of 32768 (8000
hexadecimal.
Setting
range
Section 11.4.3)
0 to 247
2 to 65535
) or more in a sequence program, set the value in
H
10.3 Z(P).MBREQ
Setting
*1
side
10
0 User
- System
0 User
11
1, 2 User
0 User
User
0 User
0
User
*3
10
- 16
9