Mitsubishi QJ71MB91 User Manual page 253

9
PROGRAMMING
CH2 Automatic CH2 Automatic
communication communication
operation status parameter setting
request/Automatic
communication
start request
Add X0E and Y0C to execute
dedicated instructions even if
automatic communication is
stopped.
Figure 9.24 Program example for executing dedicated instruction during ready status of automatic communication
9.2.3 When using the automatic communication function and the communication by dedicated instructions on the same channel
CH2 Automatic communication ready status storage area
(Automatic communication parameter 1)
Intelligent function
module switch
setting change
status
parameter 1 on channel 2
POINT
When using the automatic communication function and dedicated instructions on
the same channel, add the above
(Perform the same in the case of the MBREQ instruction)
Processing for normal completion
Processing for error completion
section to the sequence program.
9.2 Program Example for Normal System Configuration
Latch this when the start
command is a rise command.
Section 10.2,
Section 10.3
When the dedicated instruction
completes, reset the latched
start command.
9
- 24
9
10
11