Installing The Usb Drivers For Each Instrument; Connecting The Model 6470 To Your Computer - AEMC 6470 User Manual

5.4 Installing the USB Drivers for Each Instrument

INSTALL DATAVIEW
FORE CONNECTING THE INSTRUMENT TO THE COMPUTER.
The USB driver operates at two levels.
• First Level:
USB port. This is done automatically during DataView's installation.
• Second Level:
cation and the USB port. This is done when the instrument is connected
to the computer.
Upon the Second Level installation, the Found New Hardware dialog box will be
displayed. Windows will complete the driver installation process automatically.
NOTE: If you connected your instrument to the computer before installing the
software and drivers, you may need to use the Add/Remove Hardware utility to
remove the instrument driver before repeating the process.

5.5 Connecting the Model 6470 to your Computer

The Model 6470 is supplied with an optically isolated USB interface cable required
for connecting the instrument to the computer. This cable (Cat. #2135.41) is
equipped with a USB type A on one end, and an optical connector on the other
end.
To connect the Model 6470 to your computer:
1. Connect the optical connector end of the cable to the serial port on the
front panel of the Model 6470 (see § 2.3, Item #8).
2. Connect the USB type A end of the cable, to an available USB port on
your computer.
You are now ready to use the DataView
Shop for AEMC products online at:
60
SOFTWARE AS SHOWN IN THE PREVIOUS SECTION BE-
®
This level is for communication between the instrument and the
This level is for communication between the DataView appli-
ShopAEMC
www.
software with the 6470.
®
.ca
Ground Resistance Tester Model 6470
1.877.766.5412