Operation; Instrument Configuration (Set-Up Mode) - AEMC 6470 User Manual

4.1 Instrument Configuration
This function is used to change the instrument's configuration by direct access
to the parameters to be modified (either directly from the instrument or by using
DataView software).
®
To configure the Model 6470 parameters directly from the instrument's display, turn
the rotary switch to the SET-UP position:
• All the segments on the display are activated for 1 second and then the
"PUSH button" message appears on the display.
• The various parameters are accessible by pressing the corresponding but-
ton (see table below).
• The number or symbol which can be modified flashes. These are changed
using the arrow buttons ▲▼► (which are also referred to as SELECT
[▲▼] and CHANGE [►] buttons throughout the manual).
• To move to another parameter to configure,
Hz
/OPTIONS
• To exit the set-up configuration
tion.
• All of the parameters that are modified are permanently saved until a new
instrument configuration is performed.
Parameter to be modified
Distance unit
Alarm (for mW and 2-wire
measurements only)
Buzzer
Modbus address
Date
Time
Baud
Default configuration
Memory used
Shop for AEMC products online at:
*International format date and time only
Ground Resistance Tester Model 6470
CHAPTER 4

OPERATION

or MEM button (see table below).
Button
DISPLAY
DISPLAY
DISPLAY
DISPLAY
Hz/OPTIONS
Hz/OPTIONS
Hz/OPTIONS
Hz/OPTIONS
MEM
(1 press)
st
ShopAEMC
www.
(SET-UP mode)
, turn the rotary switch to another posi-
Possible values
m (meter) or ft (feet)
(1 press)
st
ON / OFF
(2 press)
nd
direction (< or >)
value (1 to 999W)
ON / OFF
(3 press)
rd
1 to 247
(4 press)
th
yyyy.mm.dd*
(1 press)
st
hh : mm*
(2 press)
nd
9.6k / 19.2k / 38.4k
(3 press)
rd
yes / no
(4 press)
th
000 to 512 (total
number of locations)
press either the DISPLAY,
.ca 1.877.766.5412
Default values
m
OFF
>
2W
ON
1
Current date*
Current time*
9.6 k bits
yes
000 on 512
23