Step 2: Install The Dash Or Vent Mount - Sirius XM RAdio ONYX EZR User Manual

Onyx EZR with Vehicle Kit User Guide

Step 2: Install the Dash or Vent Mount

Follow the instructions on the next several pages for the mounting method you have selected .
Installing the Adhesive Mount:
CAUTION! The adhesive used on the Adhesive Mount may be difficult to remove . Do
not install this mount on leather surfaces (contact your automobile dealership if you
are unsure about your dash surface), and make sure the air temperature is at least
60°F (15°C) during installation . If it's not at least 60°F, turn on the heater in your
vehicle to bring the temperature up to 60°F .
1. Locate a flat surface for the Adhesive Mount . Make sure there is ample room for
the PowerConnect Vehicle Dock and Onyx EZR Radio when installed .
2. Set the orientation of the Adhesive Mount before adhering it . Loosen the knob and adjust the
adhesive foot for the location you selected in "Step 1: Choose a Location for Your Radio" on
page 8 .
3. The dock mounting plate can be tilted in different directions . Adjust as necessary for your
particular vehicle . When the orientation is correct, tighten the knob .
4. Attach the Adhesive Mount to the PowerConnect Vehicle Dock using the
4 provided screws .
5. Before you attach the Adhesive Mount to the dash, skip ahead and finish
the remainder of the vehicle installation so that the cables are attached
to the dock .
6. Once the cables have been attached to the dock, clean the mounting
surface in the vehicle with the alcohol preparation pad and let it dry
thoroughly .
7. Peel off the adhesive liner . Position, press, and hold the Adhesive
Mount in place for 30 seconds .
IMPORTANT! Allow the Adhesive Mount adhesive to cure (dry) for a minimum
of 2-4 hours before using the mount . The best adhesion occurs after 24 hours .
TIP! To remove the Adhesive Mount, carefully lift the adhesive pad with your fingers or a
spoon . Warming the pad with a hair dryer for several minutes will help soften the adhesive .
Option 1
Option 3
Dock Mounting Plate
Knob Adhesive Foot
Option 2 Option 4
Installation
9