Programming The Primary Filter - Jacuzzi J-495 Owner's Manual

J-400
B. Econo heating:
1. This is an energy saving heating program that allows the spa to heat
during non-peak hours. When programmed to "Econo," the spa will
only be allowed to heat the water between 5:00 PM to 7:00 AM every
day of the week. The hours cannot be adjusted.
2. To select this mode, tap
C. Day heating:
1. When programmed to "Day," the spa will only be allowed to heat the
water between 7:00 AM to 5:00 PM every day of the week. The hours
cannot be adjusted.
2. To select this mode, tap
12.2

Programming the Primary Filter

To access the "Primary Filter" feature, tap
menu, Figure 12.2a, to enter the "Primary Filter" programming, Figure
12.2b.
During a primary filtration, the circulation pump, CLEARRAY and ozone
unit (if applicable) are activated. The factory default cycle starts at 12:00
AM and last for 8 hours. If you elect to keep this setting, then you can
skip this section.
In extreme bitter cold weather we recommend you program
the circulation pump to run 24 hours. Refer to the "Winterizing"
section on page 68.
Any time the circulation pump runs outside of a program cycle, e.g. for
heating, that run time will be deducted from the next primary filter cycle.
For example, the primary filter cycle is set to 8 hours every 24 hours but
the circulation pump comes on for 2 hours to heat the water after the
cycle has finished. The next primary filter cycle will only be for 6 hours
not 8 hours.
A. To change the default cycle:
When you enter the menu, "Start" and "12" will be
highlighted.
1. Tap or
increments. To switch from "AM" to "PM" you
must round a 12-Hour period.
2. Tap to accept the change.
Page 52
Heat & Filter
Auto
Econo
Day
2
1 Filter
Figure 12.2a
to change the hour in 1-hour
next to the "Econo" icon.
next to the "Day" icon.
from the Heat & Filter
1
Primary Filter
Start
End
Figure 12.2b
12pm
12
pm
8pm
Primary Filter
Start
12
End
Figure 12.2c
12pm
pm
8pm