Table of Contents
Advertisement
3A. Remove twist ties From Backrest Post (G), but leave the two Bushing
(270) parts in place.
3B. Attach Backrest Post (G) onto the Backrest Frame (D) by using:
1 - (9) Hex Bolt M12x1.75x110L
1 - (76) Nylon Nut M12x1.75x12T
2 - (52) Flat Washer D24xD13.5x2.5T
Note: Make sure the circular hand grip tube of Backrest Post (G) is on the
underside during installation.
WARNING: Do not over tighten the Hex Bolt (9) and Nylon Nut (76), doing so
may make changing the Seat and Backrest angle positions difficult.
3C. Adjust the Backrest Frame (D) by resting the Sleeve (H) into one of the
tabs along Main Frame (A).
Thoroughly tighten the hardware once complete
STEP 3
16
Advertisement
Table of Contents
