Uhlenbrock Elektronik DAISY User Manual page 15

• Press the [Turnout] key in order to confirm selection of the new "base
address". The display will now revert to indicate the speed of the
currently selected locomotive.
2.3.3 How to change the turnout format (type)
A DAISY-System can control Motorola (default) or DCC accessory
decoders. All controlled accessories (turnouts, signals, etc.) must be of
the same type: either all Motorola or all DCC. A mixed type operation of
accessory decoders is not possible.
The format of the accessory decoders can be changed only while the
DAISY throttle is connected to the "DAISY" connector of a Power2.
Attention It is not possible to edit the turnout format (type) if the DAISY throttle is
connected as an add-on throttle to a LocoNet Command Station (e.g.,
an Intellibox).
This is how to proceed:
• While in turnout mode, press the [Turnout] key. The display will
display the turnout address controlled by the [f1] key (i.e., the "base
address"), e.g.:
W
• Press the [function] key. The currently selected turnout format (type)
is displayed, e.g.:
Mot
• Rotate the encoder to select a different turnout format, e.g.:
dcc
• Press the [Turnout] key to confirm turnout type selection, or press the
[function] key to go back to turnout base address selection without
changing the turnout type.
Attention If an analog locomotive is being controlled through address 0, then
operating Motorola turnouts or signals will result in the analog
locomotive performing a short "jump", possibly in the opposite driving
direction. This can be avoided by using DCC accessory decoders.
1
15
DAISY