Uhlenbrock Elektronik DAISY User Manual page 10

• Release the [Locomotive] key. The display indicates the currently
selected locomotive address, e.g.:
• rotate the encoder in order to select the memory position you wish to
either edit or erase.
• press the [Locomotive] key and keep it pressed. The display shows:
Edit
• After about 2 seconds the locomotive address starts blinking.
• Release the [Locomotive] key: both direction LEDs will be lit.
• Rotate the encoder in order to edit the locomotive address. A faster
rotation results in a bigger address change. You can use the [Off] key
in order to erase the address. The display would then indicate:
----
TIP It is not possible to store the same locomotive address twice (that is: the
same locomotive address in two different memory locations). In fact,
each locomotive address which is already stored in an other memory
will be shown with all decimal points turned on and the DAISY will not
accept any command to memorize that address (again).
TIP DAISY-System (digital mode): if all digital locomotives have been set to
the DCC format, then it is possible to drive an analog locomotive (i.e., a
locomotive not equipped with a digital decoder) through the address 0.
That address will automatically be set to the type "DC". If such a
locomotive address is defined, then the DAISY does not generate any
Motorola locomotive digital signal anymore.
• Confirm address editing or deletion by pressing the [Locomotive] key
– or abort locomotive address editing by pressing either the [Turnout]
or [Prog] keys.
How to edit all memory locations (including the eventually erased
ones)
• Press the [Locomotive] key and keep it pressed. The display shows:
Loco
• After about 2 seconds the locomotive address will be displayed.
7
10
DAISY