Uhlenbrock Elektronik DAISY User Manual page 11

• At this point, if the rotary encoder is not operated, the display alter-
nately shows the locomotive address and the memory position, e.g.:
any memory position which has been erased will display as having
the "address":
----
• Press the [Locomotive] key and keep it pressed. The display shows:
Edit
• After about 2 seconds the locomotive address will begin to blink.
• Release the [Locomotive] key: both direction LEDs will be lit.
• Rotate the encoder in order to edit the locomotive address. A faster
rotation results in a bigger address change. You can use the [Off] key
in order to erase the address. The display will then indicate:
----
• Confirm address editing or deletion by pressing the [Locomotive] key
– or abort locomotive address editing by pressing either the [Turnout]
or [Prog] keys.
st
TIP The 1 memory position can be edited; however, it cannot be erased.
2.2.3 How to edit the locomotive format (type)
It is possible to edit the locomotive type associated with any of the 16
memory positions. In order to do that, the DAISY throttle must be
connected to the "DAISY" connector of a Power2.
Attention It is not possible to edit a locomotive type if the DAISY throttle is
connected as an add-on throttle to a LocoNet Command Station (e.g.,
to an Intellibox).
How to show the current format (type) of a locomotive
• Press the [Locomotive] key. The display indicates:
Loco
• Release the [Locomotive] key. The display will show the currently
selected locomotive address, e.g.:
• Press the [function] key. The display shows the type of the currently
selected locomotive, e.g.:
Mot1
7 -01-
  and
7
11
DAISY