Table of Contents
Advertisement
Installation and start-up
3. Press the plastic dowels into the
drill holes and screw in the two
supplied screws until the screw
heads stick out approx. 5 mm.
4. Open the battery compartment
on the device side by pressing
on the hatched area and push
the cover in the direction of the
arrow.
5. Fasten the battery clip on the
9°V block battery with the
correct polarity.
All three LEDs light up briefly
and all symbols appear in the
display. The CO alarm confirms
start-up with a beep.
26
5 mm
Advertisement
Table of Contents
