Quick Start Instructions - Intel Euclid User Manual

Quick Start Instructions

Intel® Euclid™ Development Kit provides a "zero-
installation" usage as all of the software needed to oper-
ate the device is pre-installed. For first time usage,
please follow these instructions:
1. Attach the battery to the Main Unit. It is advised to
connect the battery charger until the battery status is
known.
2. Power-on the device by pressing the POWER ON/OFF
BUTTON for 3 seconds. The SYSTEM ON LED will
illuminate green. The CHARGING LED will illuminate
red if the battery is being charged.
3. Wait for approximately 30 seconds until you hear the
chime tone indicating that the device is ready to use.
4. Power-on your personal device—either a laptop, tab-
let, smart phone or other Wi-Fi enabled device.
Please be sure that your personal device is within 3
meters of the Intel® Euclid™ Development Kit.
5. Access the settings of your personal device and use
the wireless setup facility to connect your personal
device to the Intel® Euclid™ Development Kit. Find
the SSID "EUCLID_XXXX" and connect to it (where
XXXX is an alphanumeric code that is unique to your
individual device). The password that you will need is
"12345678".
6. Open the browser on your personal device and enter
the following IP address: "http://10.42.0.1/" and hit
ENTER. This will open the main portal for the Intel®
Euclid™ Development Kit.
7. By using the device, you are accepting the software
license. A complete version of the license can be
viewed at: http://click.intel.com. After reading the
license terms, please click to accept the software li-
cense.
8. For more detailed instructions, please navigate to the
following link: http://click.intel.com. Search for the
Intel® Euclid™ Development Kit device page and the
Documentation tab for additional support material.
9. To use the cameras, choose the Cameras Scenario on
the web page. Then click on Monitor at the top of
the web page to turn on the individual cameras.
Document: CCS-G003-UM-001 Revision: Feb 2017