Intel NUC Kit NUC5PGYH User Manual
Mini pc
Hide thumbs
Also See for NUC Kit NUC5PGYH:
- Technical product specification (79 pages) ,
- User manual (10 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Intel NUC Kit NUC5PGYH
Summary of Contents for Intel NUC Kit NUC5PGYH
-
Page 1: User Guide
Intel NUC Kit NUC5PGYH User Guide Intel® NUC Kit NUC5PGYH User Guide... -
Page 2: Before You Begin
If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer chassis. Installation Precautions When you install and test the Intel NUC, observe all warnings and cautions in the installation instructions. To avoid injury, be careful of: ... - Page 3 Follow these instructions to install a 2.5” Solid State Drive (SSD) or Hard Disk Drive (HDD): 1. Observe the precautions in "Before You Begin" on page 2. 2. Open the Intel NUC chassis by unscrewing the four corner screws on the bottom cover of the chassis and lift the cover.
- Page 4 Intel NUC Kit NUC5PGYH User Guide 3. Slide the 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the connectors of the SATA daughter card (A). 4. Secure the drive into the drive bay with the two small silver screws that were included in the box (B).
-
Page 5: Upgrade Memory
Intel NUC Kit NUC5PGYH User Guide Upgrade Memory Intel NUC Kit NUC5PGYH has a 2GB DDR3L memory module already installed. You can upgrade to a larger capacity module if you wish. Memory requirements: 1.35V low voltage memory 1066 MHz or 1600 MHz SO-DIMMs (1333 MHz modules will operate at 1066 MHz) ... -
Page 6: Close The Chassis
Intel NUC Kit NUC5PGYH User Guide Close the Chassis After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by hand with a screwdriver to avoid over-tightening and possibly damaging the screws. Attach and Use the VESA Bracket (Optional) Follow these instructions to attach and use the VESA mount bracket: 1. - Page 7 3. Slide the Intel NUC onto the VESA mount bracket. Set Up Microsoft® Windows® 10 Microsoft Windows 10 is already installed on the Intel NUC Kit NUC5PGYH. The first time you start the computer, you are guided through the following Setup steps: 1.
-
Page 8: Operating System Recovery
USB 3.0 Operating System Recovery There is a Windows recovery partition on the Intel NUC. You can use this partition to Refresh, Reset, or Restore Windows. Here is what each of these actions do: Refresh If your PC isn't performing as well as it once did, and you don't know why, you can refresh your PC. - Page 9 Intel NUC Kit NUC5PGYH User Guide To access the recovery media: If Windows starts From Windows Start, type Recovery and select Recovery Options. Recovery options in Windows 10 for complete details on how to use the recovery options. If Windows does not start The recovery process should automatically start.