Advertisement
www.aeroplusrc.com
Test fit the rudder horns
Sand the area on the horn that fits inside the rudder so the glue bonds better
Glue the rudder hinges into both the rudder and fin using epoxy glue. Remember to
use Vaseline on the hinge joint. While drying, use tape to keep it in alignment..
Glue the rudder horns through the rudder with epoxy; wipe off excess glue while it is
wet. Use the ball joint and bolt while gluing to maintain alignment. While still
movable, measure that the same amount pushes out each side. Care needs to be
taken here, otherwise your rudder geometry will be incorrect.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
