Advertisement
www.aeroplusrc.com
Aileron Servos
The ailerons on the wings are pre‐glued. Check each one by gently pulling to make
sure that they are secure
Remove the covering where the aileron horns are glued in place. Use either a
soldering iron or a sharp knife
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue, use a bolt through the horns when gluing to
make sure the alignment is correct.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
