Advertisement
www.aeroplusrc.com
Unpacking
Carefully unpack the model making sure that if you use a sharp knife to open bags, not to cut any covering
on the model. Inspect each item to make sure no transit damage has happened. If you are not happy with any
part or are unsure please contact the Dealer that you purchased from.
Covering
Due to the model spending time in different climates zones from the factory on its way to you, some of
the covering may have wrinkles. We highly recommend that you take time to re‐seal all covering edges with an
iron and to use a heat gun to remove any wrinkles and re‐tighten the covering. It is best to do this now while the
plane is not assembled, remember to not let any heat get near any parts like the canopy or cowl as this may cause
damage.
Note: Do not let any heat get near parts like the canopy or cowl as this may cause damage.
Assembly Tips
We also recommend that you go over all the accessible joints with cyano glue. Wick glue into areas of
high stress around the U/C plate and motor box.
Use a thread locker on all metal‐to‐metal joints. Even if you are using electric with low vibration
levels it will make sure that things do not drop off your airplane!
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
