Advertisement
www.aeroplusrc.com
Glue the horns in place using epoxy glue or CA. Put a bolt through the ball joint hole
to make sure that the horns stay in alignment while drying.
Before fitting the elevator servo fix an extension lead so that the wire can be routed
through the the fuselage. Be sure to secure the coupling.
Remove the covering for the elevator servo
Fit the Elevator Servo and, using a fine drill, drill holes for the servo screws. Remove
the servo and drop thin C.A. into all 4 holes after first threading the servo..
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
