Jackson DishStar HT Installation, Operation And Service Manual page 17

INSTALLATION
PROGRAMMING
CHEMICAL
FEEDER PUMPS
07610-004-37-13-E
To change the value of a parameter, use the MOVE button to illuminate the light next
to the time option (time is measured in seconds). In the time categories, each second
in use will light up. To deselect the option, press ENTER and the light will go off, press
ENTER again and it will illuminate. Once you have set your time category, press the
MOVE button until the ACCEPT light illuminates and press ENTER. This will save the
changed parameters and exit the programming mode.
To change any other values, you will have to return to the programming mode. To
revert back to a previous setting, you must return to that option and change the
parameter back to the previous setting.
Once in the programming mode, if there have been no keypad inputs for approximately
two minutes, the system will automatically exit out of the programming mode. Any
changes to parameters will be lost when the programming mode is automatically
exited.
The wash and drain cycles are not adjustable.
All time adjustments are in seconds. Refer to the chart below for adjustable outputs.
PGM DishStar
E Not adjustable
F
G
H
PGM
A
B
C
D
E
F
G
H
ACCEPT
® HT DishStar
Rinse
Detergent
Rinse-Aid
TIMER PROGRAMMING BOARD
TIME IN SECONDS
MOVE
ENTER
INSTRUCTIONS
® LT/LT-H
Rinse-Aid
Fill
Sanitizer
Detergent
8
4
2
1
0.8
0.4
0.2
0.1
10