Table of Contents
Advertisement
Contents
The DRAM DIMMs on the Supervisor Engine 1A with an MSFC (WS-X6K-SUP1A-MSFC) are located
Note
beneath the MSFC. The MSFC is not field replaceable. Re-installing the MSFC could damage your
supervisor engine. To upgrade the DRAM, you must also upgrade the MSFC to an MSFC2. Both
upgrades are available in the MEM-S1-128MB-UPG= upgrade kit.
For information on removing the MSFC, refer to the Catalyst 6500 Series Multilayer Switch Feature
Card 2 Installation Note at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm
Contents
This publication consists of these sections:
•
•
•
•
•
•
•
•
•
•
•
Memory Recommendations and Requirements
See
Table 1
Catalyst Software
Release
6.x
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
2
Safety Overview, page 3
Required Tools, page 4
Removing the MSFC2, page 4
Upgrading the DRAM DIMM, page 7
Installing the MSFC2, page 9
Related Documentation, page 14
Obtaining Documentation, page 14
Documentation Feedback, page 15
Obtaining Technical Assistance, page 15
Table 1
for memory recommendations and requirements.
Memory Recommendations and Requirements
Memory
With Catalyst software releases 6.x, your Supervisor Engine 1A configuration
is fully supported with 64-MB DRAM.
Recommendation/
Requirement
78-14357-02
Advertisement
Table of Contents
