Cisco MEM-S1-128MB Installation Note page 10

Installing the MSFC2
Figure 7
Ensure that the connectors on the MSFC2 (see
Step 2
supervisor engine.
Figure 8
Edge connector
Carefully seat the MSFC2 onto the supervisor engine. (See
Step 3
November 2001 or
Step 4 Using your thumbs, apply pressure at the connector locations (shown in
before November 2001 or
MSFC2 is securely seated on the supervisor engine.
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
10
Male Standoff Location on the Supervisor Engine
WS-X5530 SWITCH LOAD
100%
1%
SUPERVISOR ENGINE I I I
CONSOLE
MSFC2 Connectors
Figure 10 for an MSFC2 shipped after November 2001.)
Figure 10
Male standoff
Figure 8) are aligned with the connectors on the
6-pin connector
Figure 9
for an MSFC2 shipped after November 2001) to ensure that the
for an MSFC2 shipped before
Figure 9 for an MSFC2 shipped
78-14357-02