Cisco MEM-S1-128MB Installation Note page 5

Supervisor engine 1a dram upgrade

Table of Contents

To remove the MSFC2 from the supervisor engine, follow these steps:

Step 1

Upload the current configuration to a server. On any modules running Cisco IOS software, save the

running configuration.

Remove the supervisor engine from the Catalyst 6500 series switch. (Refer to the Catalyst 6500 Series

Step 2

Module Installation Guide for removal instructions.)

Place the supervisor engine on an antistatic mat or foam.

Step 3

Remove the securing screws and cap nut that secure the MSFC2 to the supervisor engine. (See

Step 4

for an MSFC2 shipped before November 2001, or see

2001.)

Note

Figure 1

Hold here

78-14357-02

The MSFC2 shipped after November 2001 is physically smaller than the previous MSFC2 and

is not secured with a cap nut. (See

MSFC2 Shipped Before November 2001—Removing Securing Screws and Cap Nut

Hold here

SWITCH LOAD

WS-X5530

100%

SUPERVISOR ENGINE I I I

CONSOLE

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Figure 2

for an MSFC2 shipped after November

Figure

2.)

Removing the MSFC2

Figure 1

Table of Contents

Catalyst 6500 series