Cisco MEM-S1-128MB Installation Note page 8

Upgrading the DRAM DIMM
Figure 4
1
2
Hold the DIMM by its edges, gently lift and remove it, and place it on an antistatic mat or foam.
Step 2
(See Figure
Figure 5
DIMMs are sensitive components that are susceptible to ESD damage. To prevent ESD damage, handle
Caution
DIMMs by the edges only; avoid touching the memory modules, pins, or traces (the metal fingers along
the connector edge of the DIMM). (See
Step 3 Remove one upgrade DIMM from the antistatic container.
Step 4 Hold the DIMM by its edges. (See
Step 5 Tilt the DIMM to approximately the same angle as the socket, and insert the connector edge into the
socket. Note the notch (key) on the right connector edge of the DIMM. (See
correct orientation of the DIMM in the socket.
The Supervisor Engine 1A DRAM uses two DIMMs, one stacked on top of the other. Install the lower
Note
DIMM first.
When inserting the DIMM, use firm but not excessive pressure. If you damage a socket, you will have
Caution
to return the supervisor engine to Cisco for repair.
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
8
Removing the DRAM DIMM
5.)
Handling a DIMM
Figure
Figure 5.)
5.)
Figure 5.) This key assures
78-14357-02