Cisco MEM-S1-128MB Installation Note page 12

Installing the MSFC2
Caution Ensure that the MSFC2 is securely seated before you install and tighten the securing screws. Using the
screws to seat the MSFC2 could warp the card.
Use a Phillips-head screwdriver to install the screws and cap nut (if applicable) that secure the MSFC2
Step 5
to the supervisor engine. (See
for an MSFC2 shipped after November 2001.)
You must install the cap nut (if applicable) and all screws. The screws provide grounding between the
Caution
MSFC2 and the supervisor engine. Failure to install the cap nut and all screws will invalidate the safety
approvals and can cause fire and electrical hazards.
Figure 11
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
12
Figure 11
MSFC2 Shipped Before November 2001—Installing the Securing Screws and Cap Nut
WS-X5530 SWITCH LOAD
100%
1%
SUPERVISOR ENGINE I I I
CONSOLE
for an MSFC2 that shipped before November 2001, or Figure 12
cap nut
78-14357-02