Detecting Call Signal Clock Pulse Automatically - Philips FAXJET IPF520 User Manual

Using an External Answering
Machine
For the best operation, the answering machine must be
connected to the EXT socket of the device.
Notice
Number of Rings set on External An-
swering Machine
Make sure that a lower ring tone is set on the
external answering machine than on the device
(setting RINGS
answering machine automatically picks up each
call including faxes.
You can also change the number of rings on the fax device.
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Confirm with o. RECEPTION MODE appears on the
display.
3 Select using [ RINGS NUMBER .
4 Confirm with o.
5 Using [ select from the displayed values.
6 Confirm with o.
7 You can exit with j.
Length of Outgoing Message
Notice
Length of Outgoing Message
The outgoing message must be shorter than ten
seconds. Avoid music in your announcement. If
the external answering machine has a "conserv-
ing function" (i.e. a function that changes the
number of rings as soon as new messages have
been recorded), deactivate this function.
Answering Machine Records Fax Signals
Notice
Answering Machine Records Fax Signals
If the external answering machine records fax
signals, but your device cannot receive faxes,
inspect the connection of the external answering
machine
Detecting call signal clock
pulse automatically
Type 3 (mit Telefon)
(IPF¦525, IPF¦555)
Function is not supported in all countries and networks
(Function is not supported in all countries and
networks)
If several call numbers with different call signal clock
pulses are assigned to a telephone line by your network
operator, the device can detect these automatically. This
functions only in the PHONE/FAX or TAD/FAX operat-
ing modes.
Telephone Lines and Additional Devices · Detecting call signal clock pulse automatically
NUMBER ). Otherwise the
Start Automatic Recognition
CAUTION!
Switching of External Answering Ma-
chine
If you are using an external answering machine,
switch this off or disconnect it from the power
supply. If the external answering machine is
switched on, the recognition of the call signal
clock pulse can be disrupted.
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Select using [ INSTALLATION .
3 Confirm with o. STATION NAME appears on the
display.
4 Select using [ DISTINCT. RING .
5 Confirm with o. SET OPTION appears on the dis-
play.
6 Select using [ SET PATTERN .
7 Confirm with o. AUTODETECT RING appears on
the display.
8 Call the device with the desired telephone number (the
desired call signal clock pulse), until RING
DETECTED appears on the display of the device.
9 End the call on the caller's device.
10 Press j on the device.
The call signal clock pulse was stored.
Notice
Call Signal Clock Pulse Not Detected
If the call signal clock pulse is not detected by
the device, RING NOT DETECT. appears on
the display. Press j and repeat the process.
Switch on the Call Signal Clock
Pulse
After automatic recognition of the call signal clock pulse,
you must switch on this call signal clock pulse on your
device.
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Select using [ INSTALLATION .
3 Confirm with o. STATION NAME appears on the
display.
4 Select using [ DISTINCT. RING .
5 Confirm with o. SET OPTION appears on the dis-
play.
6 Confirm with o.
7 Select using [ YES .
8 Confirm with o.
9 You can exit with j.
EN
35