1. The pressure/temperature limits in this Instruction Manual and any applicable standard or code limitation should not be exceeded.
2. The pressure limits given are based on the body size and body materials only. Actual pressure limits of the assembled regulator may decrease and vary depending on the temperature,
body end connection, diaphragm, seat and/or trim material of the regulator.
3. See Tables 1 and 2 for all available body sizes.
4. Not available for 1/4 NPT body size.
BODY SIZE
In.
DN
1/4
- - - -
1/2
15
3/4 and 1
20 and 25
1-1/2 and 2
40 and 50
K
= F
2
m
L
Table 6. Relief Sizing Coefficients for MR95 Series Regulators with Reduced Flow Orifices
BODY SIZE
In.
1/4
1/2
3/4 and 1
1-1/2 and 2
1. The reduced flow orifice option offers similar flow capacity as the equivalent 95 series configuration.
Monel
is a mark owned by Special Metals Corporation.
®
Hastelloy
C is a mark owned by Haynes International, Inc.
®
10
Table 4. Maximum Cold Working Pressures of Body Size and Material
BODY MATERIALS
Gray cast iron
WCC Steel
LCC Steel
CF8M Stainless Steel
CF3M Stainless Steel
Monel
®(4)
Hastelloy
C
®
(4)
Gray cast iron
WCC Steel
LCC Steel
CF8M Stainless Steel
CF3M Stainless Steel
Monel
®(4)
Hastelloy
C
®
(4)
Aluminum-Bronze
(4)
WCC Steel
LCC Steel
CF8M Stainless Steel
CF3M Stainless Steel
Monel
®(4)
Hastelloy
C
®
(4)
Aluminum-Bronze
(4)
WCC Steel
LCC Steel
CF8M Stainless Steel
CF3M Stainless Steel
Monel
®(4)
Hastelloy
C
®
(4)
Aluminum-Bronze
(4)
WCC Steel
LCC Steel
CF8M Stainless Steel
CF3M Stainless Steel
Monel
®
Hastelloy
C
®
Aluminum-Bronze
Table 5. Types MR95LD and MR95HD Flow and Sizing Coefficients