Table of Contents
Advertisement
6.2.8
I: Result (All,S,F,N)
You can limit your report to only certain XDP results where "Result type" is the ruling
on an access request by XDP. The valid entries are:
ALL
SUCCESS
FAILURE
NORECORD Access request did not match any DPGroup.
To select the results rulings you would like to use to sort the report, select I:
Selection?I
Enter what type of Access Results to run the report for:
Result (All,Success,Failure,Norecord) <ALL>?failure
6.2.9
J: Production/Test results
You can limit your report to only certain XDP audit records based on whether the
audits were generated by a Test (What-if), by Production or both types of audits. To
select the type of audit, select J.
Selection?J
Do you want to include Test results (T), Production results (P)
or Both (B) types of results:
Type of results (T,P,B) <Both>?B
Valid entries are:
T
Include audit entries generated by the What-if program. Test results can include
WARNING messages.
P
Include audit entries generated by the Production XDP system. Production results can
include WARNING messages.
B
Include all audit entries.
6.2.10
K: Warning/Non-warning results
When XDP as a whole or individual DPGroups are in WARNING mode, access
requests will be granted, but an audit entry will be generated indicating that the access
would have been denied if WARNING MODE was set to OFF. To select the type of
warning, enter K at the Selection? prompt:
Selection?K
Do you want to include Warnings (W), non-warnings (N) or Both (B)
Valid entries are:
W
WARNING audit entries.
N
Normal, non-WARNING, audit entries.
B
Both WARNING and non-WARNING audit entries.
XYPRO Technology Corporation
®
XYGATE
Data Protection
Chapter 6. XDP Auditing and Audit Reports
All types of ruling results will be included in the report.
Access was allowed.
Access was denied.
™
Reference Manual
39
Proprietary and Confidential
Advertisement
Table of Contents
